User Manual Part 1

11
Regulatory Compliance and Safety Information for Cisco 800 Series Routers
OL-10260-06
Telecommunications
company. For products approved after July 23, 2001, the REN for this product is part of the product
identifier that has the format US:AAAAANNAAAAAAA. The digits represented by 01 are the REN
without a decimal point.
If this Router (Cisco 860VAE) causes har
m
to the telephone network, the telephone company will notify
you in advance that temporary discontinuance of service may be required. If advance notice is not
practical, the telephone company will notify the customer as soon as possible. Also, you will be advised
of your right to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facili
ties, equi
pment, operation, or procedures that
could affect the operation of this equipment. If this happens, the telephone company will provide
advance notice in order for you to make the necessary modifications to maintain uninterrupted service.
If trouble is experienced with this Router (Cisco 860V
AE), f
or repair or warranty information, please
contact Cisco Systems, Inc. – address: 170 West Tasman Dr. San Jose, CA95134 USA, phone number:
1 408 526 4000. If the equipment is causing harm to the telephone network, the telephone company may
request that you disconnect the equipment until the problem is resolved.
Connection to party line service is subject to state tarif
f
s. Contact the state public utility commission,
public service commission or corporation commission for information.
If your home has specially wired alarm equipment connected to the telephone line, ensure the installation
of
this equipment does not disable your alarm equipment. If you have questions about what will disable
alarm equipment, consult your telephone company or a qualified installer.
WHEN PROGRAMMING EMERGENCY NUMBERS AND/OR MAKING TEST CALLS TO
EMERGENCY NUM
B
ERS:
1. Remain on the line and briefly explain to the dispatcher the reason for the call.
2. Perform such activities in the off-peak hours, such as early morning or late evenings.
The facility interface and service order codes for the Ci
sco 800 series routers are shown in Table 2.
Cisco 800 series and SOHO series routers bearing labeling identificatio
n number US:5B1MFNA0013 or
US:5B1DLO1B0144, and Cisco 860 and 880 router models bearing labeling identification number
US:5B1ISO1B0247 comply with the following requirement:
• FCC Rules and Regulations 47 CFR Part 68
• TIA-968-A, Technical Criteria for Terminal Equipment to Prevent Harm to the Telephone Network,
July 2002, as adopted by the Administrative Council on Terminal Attachments (ACTA).
Ta b l e 2 Cisco 800 Series Routers Facility Interface and Service Order Codes
Port Type
Facility Interface
Code
Service Order
Code Jack T
ype
ISDN BRI S/T 02IS5 6.0N RJ-49C
ISDN BRI U 02IS5 6.0N RJ-49C
DSU 56K 04DU5-56 6.0N RJ-48S
ADSL Metallic — RJ-11C
SHDSL Metallic — RJ-14C
FXO 02LS2 None RJ-11C
FXO 02GS2 None RJ-21X
DID 02RV2.T AS.2 RJ-11C
Analog Modem 02LS2 None RJ-11C
Draft - Not Final Version