User Manual Part 1

Regulatory Compliance and Safety Information for Cisco 800 Series Routers

OL-10260-06

Radio

point must be installed to maintain a minimum 20 cm (7.9 in.) co-located separation distance from other

FCC approved indoor/outdoor antennas used with the access point. Any antennas or transmitters not

approved by the FCC cannot be co-located with the access point. The access point’s co-located 2.4 GHz

integrated antennas support a minimum separation distance of 8 cm (3.2 in.) and are compliant with the

applicable FCC RF exposure limit when transmitting simultaneously.

Note

Dual antennas used for diversity operation are not considered co-located.

Statement 391—Low-Power Radio Data Communications Systems (ARIB-STD)

This equipment shares a frequency band with a wide range of equipment: e.g. industrial, scientific, and

medical equipment such as microwave ovens, premises radio station (radio stations requiring licenses),

and specified low-power radio stations (radio stations not requiring licenses) for RFID used for factory

production lines as well as amateur radio stations (radio stations requiring licenses).

Before use, confirm that no premises radio stations and specified low-power radio stations for RFID

or amateur radio stations operate in your vicinity.

In the event that this equipment causes harmful interference to any premises radio station for RFID,

immediately change frequencies or halt radio wave emission and contact us at the information

indicated below for consultation on interference avoidance measures (e.g. partition installation).

any specified low-power radio stations for RFID or amateur radio stations or if other problems arise.

Administrative Rules for Cisco Wireless Devices in Taiwan

This section provides administrative rules for operating Cisco wireless access products in Taiwan. The

rules are provided in both Chinese and English.

Wireless Devices with IEEE 802.11a/b/g Radios

This equipment is limited for indoor use.

Draft - Not Final Version