Install Manual
Table Of Contents
-
9LSH U&H OO+D UGZDUH,QVWDOODWLRQ³%HWD
&RQQHFWLQJ9L SHU&HOOWR3RZHU
WARNING! Observe normal precautions for handling electronic equipment when
attaching or removing power or lan connections to the ViperCell unit.
The ViperCell combined GSM Radio and H.323 Endpoint receives power from a
power transformer that accepts 110 to 220 VAC 50/60 Hz input and produces
12VDC at 5A regulated output.
7RFRQQHFWSRZHUWRWKH9LSHU&HOO
1 Insert the DC power connector into the power connection on the top of the
ViperCell.
2 Connect the AC power connection to a standard 110-200 VAC 50/60 Hz
power source.
When power is connected, the ViperCell self-test sequence begins.
9LSHU&HOO6HOIWHVW6HTXHQFH
When power is initially applied, ViperCell performs a self-test. During self-test the
7 LED’s at the bottom of the ViperCell unit flash in a sequential pattern.
The ViperCell LED’s are identified here. (The LED’s on the ViperCell heatsink are
not labelled).
At the completion of self-test the LED’s stabilize:
• The green Power LED remains illuminated
• The green Ethernet Connect LED is illuminated
• The yellow Ethernet Active LED flashes whenever ViperCell is communi-
cating across the 100MB BaseT LAN
• The red Error LED’s are extinguished
If the self-test sequence fails to complete, or if the red Error LED’s are illuminated
contact JetCell, Inc.