User Manual

Navini Networks, Inc. Base Station User Manual
3b - Install & configure the customer EMS
Server & Client. Connect to the BTS.
4 - Enter the RFS configuration by running the
RFS script that shipped with the antenna
equipment.
2 - Are you using
the customer’s
EMS Server?
No
Yes
3a - Install & configure the
Test EMS Server & Client.
Connect to the BTS.
Excel Configuration
Form
5 - Verify that all cables are connected.
6 - Power up the BTS & reconfigure the basic
Boot Line parameters through the serial port
on the CC card.
7 - After the BTS has been powered up at least
15 minutes, perform 3 calibrations.
A
1 - Review the customer’s network plans - i.e.,
T1 vs Ethernet backhaul.
Phase III: Commissioning
Part #40-00047-01 Rev C v1.0 (1.20) 25
September 26, 2003