User Manual
Table Of Contents
- Permissions, Trademarks & Distribution
- Safety
- Regulatory Information
- Battery Precautions
- Introduction
- Package Inventory
- Ripwave Models
- Minimum Computing Requirements
- Physical Characteristics
- Installing an Ethernet Modem
- Installing a USB Modem
- Accessing the Internet
- Troubleshooting
- Uninstalling Navini Monitor
- Installing & Charging the Battery
- Care & Maintenance
- Upgrading the Modem
- ADDENDUM 1: Ripwave™ Modem - PC Troubleshooting
- ADDENDUM 2: End User Software License Agreement
Ripwave Modem User Guide Navini Networks, Inc.
10 Copyright © 2003 Navini Networks, Inc. All rights reserved. Part #40-00097-00 Rev E v1.0
July 30, 2003
Physical
Characteristics
The 2.4 GHz Ripwave Modem varies in some aspects from the 2.3,
2.5, and 2.6 models. As well, the Ethernet connection on any
model varies from a USB connection. Notice the differences
highlighted in the photos below and on the following page.
2.4 GHz Ripwave Modem
Antenna
Indicator Lights
On/Off Switch
Power Adapter
Connection
Ethernet Cable
Connection
Back of 2.4 E Back of 2.4 U
USB Cable
Connection
Antenna
Indicator Lights
On/Off Switch
Power Adapter
Connection
Ethernet Cable
Connection
Back of 2.4 E Back of 2.4 U
USB Cable
Connection