User Manual
Table Of Contents
- 3G Wireless High-Speed WAN Interface Card for Cisco1800, 2800, and 3800 Series Routers
- Contents
- Prerequisites for Configuring the Wireless WAN HWIC
- Restrictions for the Wireless WAN HWIC
- Information About the Wireless WAN HWIC
- How to Configure the Wireless WAN HWIC
- Configuration Examples for the Wireless WAN HWIC
- Command Reference
- cellular cdma profile create
- cellular cdma profile activate
- cellular cdma otasp
- debug cellular messages all
- debug cellular messages async
- debug cellular messages data
- debug cellular messages dm
- debug cellular messages management
- debug cellular messages virt-con
- show cellular all
- show cellular connection
- show cellular connection personality
- show cellular connection statistics single-user
- show cellular connection statistics multi-user
- show cellular hardware
- show cellular network
- show cellular profile
- show cellular radio
- show cellular security
- show controllers cellular
- show interfaces cellular
- show run interface cellular
- test cellular cnm-process-enqueue
- test cellular modem-power-cycle
- test cellular modem-reset
- Supported Standards, MIBs, and RFCs
- Troubleshooting
- Glossary
BETA DRAFT —CISCO CONFIDENTIAL
3G Wireless High-Speed WAN Interface Card for Cisco 1800, 2800, and 3800 Series Routers
Command Reference
13
Cisco IOS Release TBD
cellular cdma profile activate
To activate an existing CDMA profile, use the cellular cdma profile activate command in EXEC mode.
cellular slot/wic_slot/port cdma profile activate profile number
Syntax Description
Command Default There is no default for this command.
Command Modes EXEC
Command History
Usage Guidelines You can verify the profile data using the show cellular slot/wic_slot/port profile CLI.
Examples The following is a sample output of the cellular cdma profile activate command:
Rc2800#cellular 0/3/0 cdma profile activate 1
Profile 1 will become Active
Activate Profile Successful
Related Commands
slot/wic_slot/port Numeric values that indicate the router slot, WAN interface card (WIC) slot,
and port.
profile number The existing profile number you want to activate.
Release Modification
This command was introduced.
Command Description
cellular cdma profile create Creates a new CDMA profile.
cellular cdma otasp Activates a cellular account using the over the air (OTA) procedure
or over the air service provisioning (OTASP)