User Manual
Table Of Contents
- 3G Wireless High-Speed WAN Interface Card for Cisco1800, 2800, and 3800 Series Routers
- Contents
- Prerequisites for Configuring the Wireless WAN HWIC
- Restrictions for the Wireless WAN HWIC
- Information About the Wireless WAN HWIC
- How to Configure the Wireless WAN HWIC
- Configuration Examples for the Wireless WAN HWIC
- Command Reference
- cellular cdma profile create
- cellular cdma profile activate
- cellular cdma otasp
- debug cellular messages all
- debug cellular messages async
- debug cellular messages data
- debug cellular messages dm
- debug cellular messages management
- debug cellular messages virt-con
- show cellular all
- show cellular connection
- show cellular connection personality
- show cellular connection statistics single-user
- show cellular connection statistics multi-user
- show cellular hardware
- show cellular network
- show cellular profile
- show cellular radio
- show cellular security
- show controllers cellular
- show interfaces cellular
- show run interface cellular
- test cellular cnm-process-enqueue
- test cellular modem-power-cycle
- test cellular modem-reset
- Supported Standards, MIBs, and RFCs
- Troubleshooting
- Glossary
BETA DRAFT —CISCO CONFIDENTIAL
3G Wireless High-Speed WAN Interface Card for Cisco 1800, 2800, and 3800 Series Routers
2
Cisco IOS Release TBD
Figure 1 shows the GSM (HSDPA/UMTS) WAN HWIC:
Figure 1 Front Panel of the HSDPA WAN HWIC
Figure 2 shows the front panel of the CDMA (EVDO) WAN HWIC:
Figure 2 Front Panel of the EVDO WAN HWIC
The cellular WAN HWIC will provide the following software functionality:
• Dialup connection (DDR)—Dialup allows users to build up connections from a local network to
remote locations, e.g., to an Internet Provider (ISP) and to exchange data.
• Fallback connection (DDR backup)—the cellular HWIC allows the user to configure the cellular
modem to initiate a dialup connection when connection to a primary service is lost.
• Teardown after Fallback (Part of Fallback DDR)—Once a primary connection has failed and the
cellular connection is in "fallback" mode, the cellular HWIC tears down the connection once the
primary connection is available.
• Automatic teardown—After a configurable timeout value, the cellular HWIC automatically tears
down a connection if there has been no activity.
• Portable Application—You can move the router into different coverage areas (different Base stations
within the same service provider) and the router establishes a connection with the nearest cell
infrastructure automatically. This is different from the mobile capability that cell phones offer.
• Remote Access—The cellular HWIC allows users to connect with the cellular HWIC router through
the cellular network.
• Bidirectional Keepalive—The cellular HWIC allows you to configure keep alive to check the WAN
connection at an interval that you can configure. In the event of a failure of the keep-alive request,
the cellular HWIC will clear the existing connection and reestablish a new connection. This feature
works in both directions—from the cellular network to the router, and from the router to the cellular
network
• Auto-detect—The cellular HWIC automatically detects and utilizes the best available connection
from a selected service provider.
• Mobile IP Support—The cellular HWIC allows you to maintain a seamless connection while
transitioning between areas covered by different foreign agents.
Table 1 shows the different SKUs and the frequencies supported by the cellular WAN HWICs:
170842
WWAN
RSSI
UMTS
ANT
HSDPA
HWIC-
3G-GSM
Diag Port
170843
WWAN
RSSI
1xRTT
MAIN
DIV
EVDO
HWIC-
3G-CDMA
Diag Port










