User Manual

BETA DRAFT —CISCO CONFIDENTIAL
3G Wireless High-Speed WAN Interface Card for Cisco 1800, 2800, and 3800 Series Routers
Command Reference
21
Cisco IOS Release TBD
show cellular all
To display all the cellular information in one listing, use the show cellular all command in EXEC mode.
show cellular slot/wic_slot/port all
Syntax Description
Command Default There is no default for this command.
Command Modes EXEC
Command History
Usage Guidelines The command usage is the same for GSM and CDMA, though the output is different for each.
Examples The following example shows the show cellular all output for slot 0, WIC slot 0, port 0 for GSM:
c2800# show cellular 0/0/0 all
Hardware Information
====================
Modem Firmware Version = U1_2_22MCAP G:/WORK
Modem Firmware built = 04/17/06
Hardware Version = E2
International Mobile Subscriber Identity (IMSI) = <number>
International Mobile Equipment Identity (IMEI) = <number>
Factory Serial Number (FSN) = S2128751274E2OK
Modem Status = Online
Current Modem Temperature = 28 deg C, State = Normal
Profile Information
====================
Profile 1 = INACTIVE*
--------
PDP Type = IPv4, Header Compression = OFF
Data Compression = OFF
Access Point Name (APN) = vpn.com
Authentication = CHAP
Username: wapuser1, Password: wap
* - Default profile
Data Connection Information
===========================
Data Transmitted = 0 bytes, Received = 0 bytes
Profile 1, Packet Session Status = INACTIVE
slot/wic_slot/port Numeric values that indicate the router slot, WAN interface card (WIC) slot,
and port.
Release Modification
This command was introduced.