User Manual
Table Of Contents
- 3G Wireless High-Speed WAN Interface Card for Cisco1800, 2800, and 3800 Series Routers
- Contents
- Prerequisites for Configuring the Wireless WAN HWIC
- Restrictions for the Wireless WAN HWIC
- Information About the Wireless WAN HWIC
- How to Configure the Wireless WAN HWIC
- Configuration Examples for the Wireless WAN HWIC
- Command Reference
- cellular cdma profile create
- cellular cdma profile activate
- cellular cdma otasp
- debug cellular messages all
- debug cellular messages async
- debug cellular messages data
- debug cellular messages dm
- debug cellular messages management
- debug cellular messages virt-con
- show cellular all
- show cellular connection
- show cellular connection personality
- show cellular connection statistics single-user
- show cellular connection statistics multi-user
- show cellular hardware
- show cellular network
- show cellular profile
- show cellular radio
- show cellular security
- show controllers cellular
- show interfaces cellular
- show run interface cellular
- test cellular cnm-process-enqueue
- test cellular modem-power-cycle
- test cellular modem-reset
- Supported Standards, MIBs, and RFCs
- Troubleshooting
- Glossary
BETA DRAFT —CISCO CONFIDENTIAL
3G Wireless High-Speed WAN Interface Card for Cisco 1800, 2800, and 3800 Series Routers
Command Reference
22
Cisco IOS Release TBD
Inactivity Reason = Normal inactivate state
Profile 2, Packet Session Status = INACTIVE
Inactivity Reason = Normal inactivate state
Profile 3, Packet Session Status = INACTIVE
Inactivity Reason = Normal inactivate state
Profile 4, Packet Session Status = INACTIVE
Inactivity Reason = Normal inactivate state
Profile 5, Packet Session Status = INACTIVE
Inactivity Reason = Normal inactivate state
Profile 6, Packet Session Status = INACTIVE
Inactivity Reason = Normal inactivate state
Profile 7, Packet Session Status = INACTIVE
Inactivity Reason = Normal inactivate state
Profile 8, Packet Session Status = INACTIVE
Inactivity Reason = Normal inactivate state
Profile 9, Packet Session Status = INACTIVE
Inactivity Reason = Normal inactivate state
Profile 10, Packet Session Status = INACTIVE
Inactivity Reason = Normal inactivate state
c2800#
Network Information
===================
Current Service Status = No service, Service Error = None
Current Service = Invalid
Packet Service = None
Packet Session Status = Inactive
Current Roaming Status = Home
Network Selection Mode = Automatic
Country = 0, Network =
Mobile Country Code (MCC) = 0
Mobile Network Code (MNC) = 0
Location Area Code (LAC) = 0
Routing Area Code (RAC) = 255
Cell ID = 0
Primary Scrambling Code = 0
PLMN Selection = Automatic
Radio Information
=================
Current Band = None, Channel Number = 0
Current RSSI = -110 dBm
Modem Security Information
==========================
Card Holder Verification (CHV1) = Disabled
SIM Status = OK
SIM User Operation Required = None
Number of Retries remaining = 3
c2800#
The following example shows the show cellular all output for slot 0, WIC slot 3, port 0 for CDMA:
c2800#sh cellular 0/3/0 all
Hardware Information
====================
Modem Firmware Version = p2005300
Modem Firmware built = 09-13-06
Hardware Version = 1.0
Electronic Serial Number (ESN) = 0x6032692A
Preferred Roaming List (PRL) Version = 10
Current Modem Temperature = 30 degrees Celsius
Profile Information
====================