User Manual

BETA DRAFT —CISCO CONFIDENTIAL
3G Wireless High-Speed WAN Interface Card for Cisco 1800, 2800, and 3800 Series Routers
Command Reference
25
Cisco IOS Release TBD
show cellular connection
To display the current active connection state and statistics, use the show cellular connection command
in EXEC mode.
show cellular slot/wic_slot/port connection
Syntax Description
Command Default There is no default for this command.
Command Modes EXEC
Command History
Usage Guidelines The command usage is the same for GSM and CDMA, though the output is different for each.
Examples The following example shows output for code division multiple access (CDMA) for slot 0, WIC slot 0,
port 0:
c2800#sh cellular 0/0/0 connection
Phone number of outgoing call = #777
HDR AT State = Connected, HDR Session State = Open
HDR Session Info:
UATI (Hex) = 0080:0580:0000:0000:000A:CCC5:45C1:8E52
Color Code = 237, RATI = 0xC739C302
Session duration = 672 msecs, Session start = 368388914 msecs
Session end = 368390063 msecs, Authentication Status = Not authenticated
HDR DRC Value = 9, DRC Cover = 1, RRI = 38.4 kbps
Current Transmitted = 379707 bytes, Received = 374429 bytes
Total Transmitted = 83514 KB, Received = 454699 KB
Current Call Status = CONNECTED
Privacy Mode = OFF, Service Option = 33023
Current Call Duration = 1554 secs
Total Call Duration = 234255 seconds
Current Call State = AT Packet Call
Last Call Disconnect Reason = Base station release (No reason)
Last Connection Error = None
HDR DDTM (Data Dedicated Transmission Mode) Preference = Off
Mobile IP Error Code (RFC-2002) = 0 (Registration accepted)
Table 8 describes the output fields for CDMA for this command:
slot/wic_slot/port Numeric values that indicate the router slot, WAN interface card (WIC) slot,
and port.
Release Modification
This command was introduced.