User Manual
Table Of Contents
- 3G Wireless High-Speed WAN Interface Card for Cisco1800, 2800, and 3800 Series Routers
- Contents
- Prerequisites for Configuring the Wireless WAN HWIC
- Restrictions for the Wireless WAN HWIC
- Information About the Wireless WAN HWIC
- How to Configure the Wireless WAN HWIC
- Configuration Examples for the Wireless WAN HWIC
- Command Reference
- cellular cdma profile create
- cellular cdma profile activate
- cellular cdma otasp
- debug cellular messages all
- debug cellular messages async
- debug cellular messages data
- debug cellular messages dm
- debug cellular messages management
- debug cellular messages virt-con
- show cellular all
- show cellular connection
- show cellular connection personality
- show cellular connection statistics single-user
- show cellular connection statistics multi-user
- show cellular hardware
- show cellular network
- show cellular profile
- show cellular radio
- show cellular security
- show controllers cellular
- show interfaces cellular
- show run interface cellular
- test cellular cnm-process-enqueue
- test cellular modem-power-cycle
- test cellular modem-reset
- Supported Standards, MIBs, and RFCs
- Troubleshooting
- Glossary
BETA DRAFT —CISCO CONFIDENTIAL
3G Wireless High-Speed WAN Interface Card for Cisco 1800, 2800, and 3800 Series Routers
Command Reference
36
Cisco IOS Release TBD
The following example shows output for global system for mobile communication (GSM) for slot 0,
WIC slot 0, port 0:
# show cellular
0/0/0
hardware
Modem Firmware Version = H1_0_0_1MCAP C:/WS/
Modem Firmware built = 09/08/06
Hardware Version = 1.0
International Mobile Subscriber Identity (IMSI) = <
number
>
International Mobile Equipment Identity (IMEI) = <
number
>
Factory Serial Number (FSN) = X2819460254100D
Modem Status = Online
Current Modem Temperature = 33 deg C, State = Normal
Related Commands
Preferred Roaming List (PRL) Version PRL version is unique to a service provider. This
indicates to the modem which channels the
modem should scan.
Current Modem Temperature Radio temperature of the modem in celsius.
Table 4 Output Description for show cellular hardware command for CDMA (continued)
Field Description
Table 5 Output Description for show cellular hardware command for GSM
Field Description
Modem Firmware Version Firmware version of the modem.
Modem Firmware Built Date firmware was built in mm-dd-yy format
Hardware Version Modem hardware version.
International Mobile Subscriber Identity (IMSI) IMSI is stored in the SIM. IMSI consists of MCC
(mobile country code, 3 digits), MNC (mobile
network code, 3 for N. America and 2 digits for
rest of the world) and MSIN (mobile station
identification number). The MCC and MNC in the
IMSI identify the subscribers PLMN (Public Land
Mobile Network).
International Mobile Equipment Identity (IMEI) Number that uniquely identifies the modem in a
GSM/UMTS network.
Factory Serial Number (FSN) Unique serial number of the modem.
Modem Status Will be online if the modem has booted up fine,
otherwise will be offline and the modem will be
unusable.
Current Modem Temperature Radio temperature of the modem in celsius. State
is normal when temperature is between -15 deg C
to 85 deg C. If state reaches critical (108 deg C),
the modem will be shutdown.
Command Description
cellular cdma profile activate Displays all the show cellular information in one listing.
cellular cdma otasp Displays the current active connection state and statistics.
debug cellular messages data Displays the cellular network (base station) information.