User Manual

BETA DRAFT —CISCO CONFIDENTIAL
3G Wireless High-Speed WAN Interface Card for Cisco 1800, 2800, and 3800 Series Routers
Command Reference
38
Cisco IOS Release TBD
show cellular network
To display the cellular network (base station) information, use the show cellular network command in
EXEC mode.
show cellular slot/wic_slot/port network
Syntax Description
Command Default There is no default for this command.
Command Modes EXEC
Command History
Usage Guidelines The command usage is the same for GSM and CDMA, though the output is different for each.
Examples The following example shows output for code division multiple access (CDMA) for slot 0, WIC slot 0,
port 0:
# show cellular 0/0/0 network
Current Service = 1xEV-DO and 1xRTT
Current Roaming Status(1xRTT) = HOME, (HDR) = HOME
Current Idle Digital Mode = HDR
Current System Identifier (SID) = 40
Current Network Identifier (NID) = 2
Serving Base Station Longitude = 0 deg 0 min 0 sec
Serving Base Station Latitude = 0 deg 0 min 0 sec
Current System Time = Tue Sep 26 13:49:22 2006
slot/wic_slot/port Numeric values that indicate the router slot, WAN interface card (WIC) slot,
and port.
Release Modification
This command was introduced.
Table 6 Output Description for show cellular hardware command for GSM
Field Description
Current Service Service attached by the modem.
Current Roaming Status Indicates whether the modem is in the home
network or roaming.
Current Idle Digital Mode Idle mode of the modem.
Current System Identifier SID received by the modem (applicable only for
1xRTT)
Current Network Identifier NID received by the modem (applicable only for
1xRTT).