User Manual

BETA DRAFT —CISCO CONFIDENTIAL
3G Wireless High-Speed WAN Interface Card for Cisco 1800, 2800, and 3800 Series Routers
Command Reference
47
Cisco IOS Release TBD
show cellular security
To display the modem lock state, use the show cellular security command in user EXEC mode.
show cellular slot/wic_slot/port security
Syntax Description
Command Default There is no default for this command.
Command Modes EXEC
Command History
Usage Guidelines The command usage is the same for GSM and CDMA, though the output is different for each.
Examples The following example shows output for code division multiple access (CDMA) for slot 0, WIC slot 0,
port 0:
# show cellular 0/0/0 security
Modem PIN Security LOCKED
Power-up lock ENABLED
Table 12 describes the output for this command:
The following example shows output for global system for mobile communication (GSM) for slot 2,
WIC slot 1, port 1:
# show cellular 0/0/0 security
Card Holder Verification (CHV1) ENABLED
SIM Status = OK
SIM User Operation Required = CHV1
Number of Retries remaining = 3
slot/wic_slot/port Numeric values that indicate the router slot, WAN interface card (WIC) slot,
and port.
Release Modification
This command was introduced.
Table 12 Output Description
Field Description
Modem PIN Security If the modem is locked, you cannot make calls
without unlocking.
Power-up Lock Shows whether the modem will be locked on
power-up.