User Manual

BETA DRAFT —CISCO CONFIDENTIAL
3G Wireless High-Speed WAN Interface Card for Cisco 1800, 2800, and 3800 Series Routers
Command Reference
50
Cisco IOS Release TBD
show interfaces cellular
To display statistics for the cellular interfaces, use the show interfaces cellular command in EXEC
mode.
show interfaces cellular slot/wic_slot/port
Syntax Description
Command Default There is no default for this command.
Command Modes EXEC
Command History
Usage Guidelines When you enter this command, encapsulation should be PPP and all signals, like DCD, DSR, DTR, RTS
and CTS should be up during normal operation.
Examples The following example shows the cellular interface statistics for slot 0, WIC slot 0, port 0; the
encapsulation in the example is SLIP and DTR is down:
c2800# show interfaces cellular 0/0/0
Cellular0/0/0 is down, line protocol is down
Hardware is HSDPA North America
MTU 1500 bytes, BW 9 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation SLIP, loopback not set
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/0/16 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 6 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
DCD=up DSR=up DTR=down RTS=up CTS=up
c2800#
slot/wic_slot/port Numeric values that indicate the router slot, WAN interface card (WIC) slot,
and port.
Release Modification
This command was introduced.