User's Manual

12-7
Cisco 3200 Series Wireless MIC Software Configuration Guide
OL-7734-02
Chapter 12 Configuring Filters
Configuring Filters Using the Web-Browser Interface
Step 13 Select Forward or Block from the Action menu.
Step 14 Click Add. The protocol appears in the Filters Classes field. To remove the protocol from the Filters
Classes list, select it and click Delete Class. Repeat Step 12 to Step 14 to add protocols to the filter.
Step 15 When the filter is complete, click Apply. The filter is saved on the WMIC, but it is not enabled until you
apply it on the Apply Filters page.
Step 16 Click the Apply Filters tab to return to the Apply Filters page. Figure 12-4 shows the Apply Filters page.
Figure 12-4 Apply Filters Page
Step 17
Select the filter name from one of the IP drop-down menus. You can apply the filter to either or both the
Ethernet and radio ports, and to either or both incoming and outgoing packets.
Step 18 Click Apply. The filter is enabled on the selected ports.
Configuring and Enabling Ethertype Filters
Ethertype filters prevent or allow the use of specific protocols through the WMIC’s Ethernet and radio
ports. You can apply the filters you create to either or both the Ethernet and radio ports and to either or
both incoming and outgoing packets.
Use the Ethertype Filters page to create Ethertype filters. Figure 12-5 shows the Ethertype Filters page.