User's Manual

12-9
Cisco 3200 Series Wireless MIC Software Configuration Guide
OL-7734-02
Chapter 12 Configuring Filters
Configuring Filters Using the Web-Browser Interface
Step 9 Click Apply. The filter is saved on the WMIC, but it is not enabled until you apply it on the Apply Filters
page.
Step 10 Click the Apply Filters tab to return to the Apply Filters page. Figure 12-6 shows the Apply Filters page.
Figure 12-6 Apply Filters Page
Step 11
Select the filter number from one of the Ethertype drop-down menus. You can apply the filter to either
or both the Ethernet and radio ports, and to either or both incoming and outgoing packets.
Step 12 Click Apply. The filter is enabled on the selected ports.