User's Manual

2-16
Cisco 3200 Series Wireless MIC Software Configuration Guide
OL-7734-02
Chapter 2 Configuring the WMIC for the First Time
Protecting Your Wireless LAN
Default Settings on the Express Setup Page
Table 2-1 lists the default settings for the settings on the Express Setup page.
Protecting Your Wireless LAN
After you assign basic settings to your WMIC, you must configure security settings to prevent
unauthorized access to your network. Because it is a radio device, the WMIC can communicate beyond
the physical boundaries of your building. You can use Express Security page in the Configuring Basic
Security Settings section to set basic security settings for your WMIC. Advanced security features can
be found in the following chapters:
• A unique SSID that are not broadcast in the beacon (see Chapter 5, “Configuring SSIDs”
• WEP and WEP features (see Chapter 7, “Configuring WEP and WEP Features”)
• Dynamic WEP and WMIC authentication (see Chapter 8, “Configuring Authentication Types”)
Table 2-1 Default Settings on the Express Setup Page
Setting Default
System Name bridge
Configuration Server Protocol DHCP
IP Address Assigned by DHCP by default; if DHCP is disabled, the default
setting is 10.0.0.1
IP Subnet Mask Assigned by DHCP by default; if DHCP is disabled, the default
setting is 255.255.255.224
Default Gateway Assigned by DHCP by default; if DHCP is disabled, the default
setting is 0.0.0.0
SNMP Community defaultCommunity
Role in Radio Network Install-Mode
Optimize Radio Network for Default
Aironet Extensions Enable