User's Manual

2-25
Cisco 3200 Series Wireless MIC Software Configuration Guide
OL-7734-02
Chapter 2 Configuring the WMIC for the First Time
Using the IP Setup Utility
Step 7 Download and save the file to a temporary directory on your hard drive and then exit the Internet browser.
Step 8 Double-click IPSUvxxxxxx.exe in the temporary directory to expand the file.
Step 9 Double-click Setup.exe and follow the steps provided by the installation wizard to install IPSU.
The IPSU icon appears on your computer desktop.
Using IPSU to Find the WMIC IP Address
If your WMIC receives an IP address from a DHCP server, you can use IPSU to find its IP address.
Because IPSU sends a reverse-ARP request based on the MAC address, you must run IPSU from a
computer on the same subnet as the WMIC. Follow these steps to find the IP address:
Step 1 Double-click the IPSU icon on your computer desktop to start the utility. The IPSU screen appears (see
Figure 2-4).
Figure 2-4 IPSU Get IP Address Screen
Step 2
When the utility window opens, make sure the Get IP addr radio button in the Function box is selected.
Step 3 Enter the WMIC MAC address in the Device MAC ID field. The WMIC MAC address should contain
six pairs of hexadecimal digits. The MAC address might look like the following example:
000164xxxxxx
Note The MAC address field is not case-sensitive.
Step 4 Click Get IP Address.
Step 5 When the IP address appears in the IP Address field, write it down.
If IPSU reports that the IP address is the default IP address, the WMIC did not receive a DHCP-assigned
IP address. To change the IP address by using IPSU, refer to the “Using IPSU to Set the IP Address and
SSID” section.