User's Manual

2-26
Cisco 3200 Series Wireless MIC Software Configuration Guide
OL-7734-02
Chapter 2 Configuring the WMIC for the First Time
Using the IP Setup Utility
Using IPSU to Set the IP Address and SSID
To change the IP address of the WMIC, use IPSU. You can also set the SSID.
Note IPSU can change the IP address and SSID only from the default settings. After the IP address and SSID
have been changed, IPSU cannot be used to change them again.
Note The computer you use to assign an IP address to the WMIC must have an IP address in the same subnet
as the WMIC.
Follow these steps to assign an IP address and an SSID to the WMIC:
Step 1 Double-click the IPSU icon on your computer desktop to start the utility.
Step 2 Click the Set Parameters radio button in the Function box (see Figure 2-5).
Figure 2-5 IPSU Set Parameters Screen
Step 3
Enter the WMIC MAC address in the Device MAC ID field. The MAC address should contain six pairs
of hexadecimal digits. Your MAC address might look like this example:
004096xxxxxx
Note The MAC address field is not case-sensitive.
Step 4 Enter the IP address you want to assign to the WMIC in the IP Address field.
Step 5 Enter the SSID you want to assign to the WMIC in the SSID field.
Note You cannot set the SSID without also setting the IP address. However, you can set the IP address
without setting the SSID.