User's Manual
Table Of Contents
- Declarations of Conformity and Regulatory Information for Cisco Access Products with 802.11a/b/g ...
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Wireless Access Products in Japan
- Administrative Rules for Cisco Wireless Devices in Taiwan
- Declaration of Conformity Statements
- Declaration of Conformity Statements for European Union Countries
7
Declarations of Conformity and Regulatory Information for Cisco Access Products with 802.11a/b/g and 802.11b/g Radios
78-16887-01
European Community, Switzerland, Norway, Iceland, and Liechtenstein
National Restrictions
The 2.400- to 2483.5-MHz band is available in all EU member states for indoor as well as outdoor usage.
In the majority of the countries, the maximum power allowed is 100 mW eirp.
With regard to operation in the 5-GHz bands, these products meet the requirements as specified in the
Guidance Document produced by the CEPT/ECC WG FM for ‘Interim Arrangements for 5-GHz
Wireless LANs’ (September 2002). The equipment can operate in either band (5150- to 5250-MHz or
5150- to 5350-Mhz) and is intended to be placed on the market only in those countries that have a
permanent or interim regulation in place by which the equipment without DFS (radar detection) is
allowed to operate in part of the 5-GHz frequency band and if applicable, at a reduced output power
level.
For all countries, the operation in the 5-GHz bands (5150- to 5350-MHz) is restricted to indoor use only.
Table 2 contains an overview of the countries in which the product is intended to be placed on the market
together with the applicable frequency band and the maximum allowed power (eirp).
Cisco recommends that you check with the local authorities for the latest status of their national
regulations for Wireless LANs or for regulations in countries not listed in Table 2.
The following sections identify EU countries having additional requirements or restrictions than those
listed in Table 2.
Italy
This product meets the National Radio Interface and the requirements specified in the National
Frequency Allocation Table for Italy. Unless operating within the boundaries of the owner’s property,
the use of these wireless LAN products requires a ‘general authorization.’
Check the following URL for more information:
http://www.comunicazioni.it/it/
49325
Table 2 Country Specific Frequency Ranges and Power Levels
Countries Frequency (MHz) Power Level (mW) eirp
All EU countries 2400–2483.5 100
DK, NO 5150–5250 50
AT, DE, IT, PT 5150–5250 60
FR, NL, SI, SK 5150–5250 200
BE, FI, IR, UK, LU, ES,
CH , LI
5150–5350 120
GR, PL 5150–5350 200