User's Manual

8
Declarations of Conformity and Regulatory Information for Cisco Access Products with 802.11a/b/g and 802.11b/g Radios
78-16887-01
European Community, Switzerland, Norway, Iceland, and Liechtenstein
France
Check the following URL for more information:
http://www.art-telecom.fr/
Belgium
Check the following URL for more information:
http://www.bipt.be/langue.htm
Note Although Norway, Switzerland, and Liechtenstein are not EU member states, the EU Directive
1999/5/EC has also been implemented in those countries.
Note The regulatory limits for maximum output power are specified in eirp. The eirp level of a device can be
calculated by adding the gain of the antenna used (specified in dBi) to the output power available at the
connector (specified in dBm).
Products with External Antennas
Cisco wireless access routers or AP HWICs can be shipped with external antennas. Table 3 lists the
antennas that were assessed together with the equipment against the requirements of the R&TTE
directive. Depending on the country, a different regulatory limit might be applicable. It is therefore the
responsibility of the end user to select a power level that, together with the antenna, results in an eirp
level that is below the applicable limit.
The maximum conducted power setting for each of the antennas and the applicable regulatory limits is
provided in Table 3. See the “National Restrictions” section on page 7 to identify the regulatory limit in
your country.
Table 3 Maximum Allowed Conducted Power Settings to Meet Regulatory Limits for Output Power (eirp)
Cisco Product and Antenna
Gain
(dBi)
Frequency
Band (GHz)
Regulatory
Limit (eirp)
(mW)
Maximum
Conducted
Power
Setting (dBm) Antenna Description
Cisco product with 802.11a/b/g
radio and antenna
AIR-ANT-M2050D-R
2.0 2.4 100 17 Swivel-mount dipole
5 5 50 11
60 11
120 17
200 17
Cisco product with 802.11a/b/g
radio and antenna
AIR-ANT-M4050V-R
4.0 2.4 100 15 Diversity omnidirectional
ceiling-mount
5 5 50 11
60 11
120 17
200 17