User's Manual
Table Of Contents
- Declarations of Conformity and Regulatory Information for Cisco Access Products with 802.11a/b/g ...
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Department of Communications—Canada
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity for RF Exposure
- Guidelines for Operating Cisco Wireless Access Products in Japan
- Administrative Rules for Cisco Wireless Devices in Taiwan
- Declaration of Conformity Statements
- Obtaining Documentation
- Documentation Feedback
- Cisco Product Security Overview
- Obtaining Technical Assistance
- Obtaining Additional Publications and Information
2
Declarations of Conformity and Regulatory Information for Cisco Access Products with 802.11a/b/g and 802.11b/g Radios
78-16887-01
Manufacturers Federal Communication Commission Declaration of Conformity Statement
Manufacturers Federal Communication Commission
Declaration of Conformity Statement
FCC Certification numbers:
LDKXSARCD11—802.11a/b/g
LDKXSNIAG13—802.11b/g
Manufacturer:
Hon Hai Precision Ind. Co., Ltd.
Hsinchu Science Park Branch Office
5F-1, 5 Hsin-An Road
Hsinchu, Science-Based Industrial Park
Taiwan, R.O.C.
and
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134
This device complies with Part 15 rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a residential environment. This equipment generates,
uses, and radiates radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference. However, there is no guarantee that interference will not
occur. If this equipment does cause interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician.