User Manual

Contents
xiv
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Monitoring and Maintaining uRPF 13-14
Configuration Examples of uRPF 13-16
Configuring Loose Mode uRPF 13-17
Configuring Loose Mode uRPF with the allow-self-ping Option 13-17
Configuring Loose Mode uRPF with the allow-default Option 13-18
CHAPTER 14 Configuring Automatic Protection Switching 14-19
Multirouter Automatic Protection Switching 14-19
Feature History for MR-APS 14-20
Restrictions for MR-APS 14-21
Configuration Tasks for MR-APS 14-21
Configuring MR-APS on Unchannelized Line Cards 14-21
Configuring MR-APS on Channelized Line Cards 14-22
Configuring MR-APS with Static Routes 14-23
Configuring MR-APS with Static Routes on Unchannelized Line Cards 14-23
Configuring MR-APS with Static Routes on Channelized Line Cards 14-25
Monitoring and Maintaining the MR-APS Configuration 14-27
Single-router Automatic Protection Switching 14-27
Feature History for SR-APS 14-29
Configuring SR-APS 14-29
Disabling SR-APS 14-29
Monitoring and Maintaining the SR-APS Configuration 14-30
Threshold Commands 14-31
Specifying SR-APS Signal Degrade BER Threshold 14-31
Specifying SR-APS Signal Fail BER Threshold 14-32
CHAPTER 15 Configuring IP Multicast 15-33
Feature History for IP Multicast 15-34
Restrictions for IP Multicast 15-34
Configuration Tasks for IP Multicast Routing 15-34
Enabling IP Multicast Routing 15-35
Enabling PIM on an Interface 15-35
Enabling Dense Mode 15-35
Enabling Sparse Mode 15-36
Enabling Sparse-Dense Mode 15-36
Configuring Native Multicast Load Splitting 15-36
Configuring the Control Plane Protocol Policy 15-36