User Manual

Contents
xviii
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Restrictions for PPP over MPLS 18-36
Configuring HDLC over MPLS or PPP over MPLS 18-36
Estimating the Size of Packets Traveling Through the Core Network 18-37
Estimating Packet Size—Example 18-38
Changing the MTU Size on P and PE Routers 18-38
Setting Experimental Bits with AToM 18-38
Configuring QoS Features 18-40
Monitoring and Maintaining L2VPN 18-43
Configuration Example—Frame Relay over MPLS 18-44
Any Transport over MPLS—Tunnel Selection 18-47
Configuration Example—Any Transport over MPLS: Tunnel Selection 18-47
CHAPTER 19 Configuring Multilink Point-to-Point Protocol Connections 19-1
Multilink Point-to-Point Protocol 19-2
Feature History for Multilink PPP 19-3
MLP Bundles 19-3
Restrictions for MLP Bundles 19-3
MLP Bundles and PPP Links 19-4
System Limits for MLP Bundles 19-4
Cisco 10000 series routers do not support VAI bundle interfaces in a PTA configuration. VAI bundles are
supported only on the L2TP network server (LNS) for MLPoLNS.MLP Groups 19-5
How MLP Determines the Link a Bundle Joins 19-5
IP Addresses on MLP-Enabled Links 19-6
Valid Ranges for MLP Interfaces 19-7
MLP Overhead 19-8
Configuration Commands for MLP 19-8
interface multilink Command 19-8
ppp multilink Command 19-9
ppp multilink fragment-delay Command 19-9
ppp multilink interleave Command 19-10
ppp multilink fragment disable Command 19-11
ppp multilink group Command 19-11
MLP over Serial Interfaces 19-12
Performance and Scalability for MLP over Serial Interfaces 19-13
Restrictions and Limitations for MLP over Serial Interfaces 19-13
Single-VC MLP over ATM Virtual Circuits 19-14
Performance and Scalability for Single-VC MLP over ATM 19-14
Restrictions and Limitations for Single-VC MLP over ATM 19-14