Installation guide

v
Cisco 1750 Router Hardware Installation Guide
78-6169-02
VIC Cables and Pinouts
VIC Cables and Pinouts
This section describes the VIC cables and pinouts for foreign exchange station
(FXS), foreign exchange office (FXO), and E&M connectors. Use the following
cables to connect the VICs to the network:
• Standard RJ-11 modular telephone cable to connect FXS VIC ports
(color-coded gray) to a telephone or fax machine.
• Standard RJ-11 modular telephone cable to connect FXO VIC ports
(color-coded pink) to the PSTN or to a PBX that does not support E&M
signaling.
• Standard RJ-48S connector and cable to connect E&M VIC ports
(color-coded brown) to a PBX line. The cable wiring depends on the PBX
type and connection. For details refer to the Cisco WAN Interface Cards
Hardware Installation Guide.
Figure 2 shows how to connect the VICs to the network.
Figure 2 Connecting VICs to the Network
Table 4 lists the pinouts for FXS and FXO VIC connectors.
SEE MANUAL BEFORE INSTALLATION
VIC
E&M
IN USE IN USE
1 0
SEE MANUAL BEFORE INSTALLATION
VIC
FXO
IN USE IN USE
1 0
SEE MANUAL BEFORE INSTALLATION
VIC
FXS
IN USE IN USE
1 0
PBX
FXS VIC
FXO VIC
E&M VIC
10691