Specifications

xlv
Cisco 1751 Router Software Configuration Guide
OL-1070-01
show dial-peer voice
To display configuration information for dial peers, use the show dial-peer voice privileged EXEC
command.
show dial-peer voice [number]
Syntax Description
Command Mode
Privileged EXEC.
Usage Guidelines
Use the show dial-peer voice privileged EXEC command to display the configuration for all VoIP and
POTS dial peers configured for the router. To show configuration information for only one specific dial
peer, use the argument number to identify the dial peer.
Sample Display
The following is sample output from the show dial-peer voice command for a POTS dial peer:
router# show dial-peer voice 1
VoiceEncapPeer1
tag = 1, dest-pat = `14085551000',
answer-address = `',
group = 0, Admin state is up, Operation state is down
Permission is Both,
type = pots, prefix = `',
session target = `', voice port =
Connect Time = 0, Charged Units = 0
Successful Calls = 0, Failed Calls = 0
Accepted Calls = 0, Refused Calls = 0
Last Disconnect Cause is “”
Last Disconnect Text is “”
Last Setup Time = 0
number Displays configuration for the dial peer identified by the argument number.
Valid entries are any integers that identify a specific dial peer, from 1 to 32767.