User Guide

Getting Started
This chapter provides information about the Mobility Express ports, interfaces, WLANs, LED states and
access switch configuration.
•
Ports, on page 1
• Interfaces, on page 2
• WLANs, on page 2
• Switch Configuration, on page 2
Ports
A port is a physical entity that is used to connect Cisco 1800 series access points to the network. The ports
available on Cisco 1800 Access Points are as shown.
Figure 1: Ports of Cisco 1800 series Access Points
Mode
The Mode button is used to reset the Access Point to factory defaults. T o reset, depress the button and connect
power to the AP. Hold the button depressed for 20s and then release it. When the button is released, the
following message will be seen in the console. The AP will reboot and will be reset to factory defaults. If the
AP has the Mobility Express controller image, after the reboot, it will broadcast the CiscoAirProvision SSID.
Getting Started
1