Specifications

2-489
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13270-06
Chapter Cisco Catalyst Blade Switch 3130 for Dell Cisco IOS Commands
show controllers ethernet-controller
show controllers ethernet-controller
Use the show controllers ethernet-controller command in EXEC mode without keywords to display
per-interface send and receive statistics read from the hardware.
show controllers ethernet-controller [interface-id] [phy [detail]] [port-asic {configuration |
statistics}]
Syntax Description
Command Modes User EXEC
Privileged EXEC
Command History
Usage Guidelines This display without keywords provides traffic statistics, basically the RMON statistics for all interfaces
or for the specified interface.
Only supported with the interface-id keywords in user EXEC mode.
Use with the phy keyword to display the interface internal registers or the port-asic keyword to display
information about the port ASIC.
When you enter the phy or port-asic keywords, the displayed information is useful primarily for Cisco
technical support representatives troubleshooting the switch.
interface-id The physical interface (including type, stack member, module, and port number).
phy (Optional) Display the status of the internal registers on the switch physical layer
device (PHY) for the device or the interface. This display includes the operational
state of the automatic medium-dependent interface crossover (auto-MDIX)
feature on an interface.
detail (Optional) Display details about the PHY internal registers.
port-asic (Optional) Display information about the port ASIC internal registers.
configuration Display port ASIC internal register configuration.
statistics Display port ASIC statistics, including the Rx/Sup Queue and miscellaneous
statistics.
Release Modification
12.2(40)EX1 This command was introduced.