Specifications

2-496
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13270-06
Chapter Cisco Catalyst Blade Switch 3130 for Dell Cisco IOS Commands
show controllers ethernet-controller fastethernet
show controllers ethernet-controller fastethernet
Use the show controllers ethernet-controller fastethernet command in EXEC mode to display
information about the Ethernet management port, including the port status and the per-interface send and
receive statistics read from the hardware.
show controllers ethernet-controller fastethernet 0 [phy [detail] | stack]
Syntax Description
Command Modes User EXEC
Privileged EXEC
Command History
Usage Guidelines The output display provides information that might be useful for Cisco technical support representatives
troubleshooting the switch.
Only supported with the fastethernet 0 keywords in user EXEC mode.
Examples This is an example of output from the show controllers ethernet-controller fastethernet 0 command.
See Table 2-32 and Table 2-33 for descriptions of the Transmit and Receive fields.
Switch# show controller ethernet-controller fastethernet 0
Transmit FastEthernet0 Receive
5925 Bytes 33181 Bytes
0 Unicast frames 78 Unicast frames
15 Multicast frames 437 Multicast frames
1 Broadcast frames 0 Broadcast frames
0 Too old frames 0 Unicast bytes
0 Deferred frames 0 Multicast bytes
0 MTU exceeded frames 0 Broadcast bytes
0 1 collision frames 0 Alignment errors
0 2 collision frames 0 FCS errors
0 3 collision frames 0 Oversize frames
0 4 collision frames 0 Undersize frames
phy [detail] (Optional) Display the status of the internal registers on the switch physical layer
device (PHY) for the Ethernet management port on the switch when the command
is entered on a switch. Display the status of the internal registers on the switch
PHYs for all the Ethernet management ports in the switch stack when the
command is entered on a stack master or member.
Use the detail keyword to display details about the PHY internal registers.
This display includes the operational state of the automatic medium-dependent
interface crossover (auto-MDIX) feature on an interface.
stack (Optional) Display the speed, duplex mode, and link states of the Ethernet
management ports in the switch stack when the command is entered on a stack
master or member.
Release Modification
12.2(40)EX1 This command was introduced.