Specifications

2-533
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13270-06
Chapter Cisco Catalyst Blade Switch 3130 for Dell Cisco IOS Commands
show interfaces
Command Modes Privileged EXEC
Command History
Usage Guidelines The show interfaces capabilities command with different keywords has these results:
• se the show interface capabilities module number command to display the capabilities of all
interfaces on that switch in the stack. If there is no switch with that module number in the stack,
there is no output.
• se the show interface capabilities module 1 command to display the capabilities of all interfaces
on the switch. Any other number is invalid.
• Use the show interfaces interface-id capabilities to display the capabilities of the specified
interface.
• se the show interfaces capabilities (with no module number or interface ID) to display the
capabilities of all interfaces in the stack.
• se the show interfaces capabilities (with no module number or interface ID) to display the
capabilities of all interfaces on the switch.
• se the show interface switchport module number command to display the switch port
characteristics of all interfaces on that switch in the stack. If there is no switch with that module
number in the stack, there is no output.
• se the show interface switchport module 1 to display the switch port characteristics of all
interfaces on the switch. Any other number is invalid.
Note Though visible in the command-line help strings, the crb, fair-queue, irb, mac-accounting,
precedence, random-detect, rate-limit, and shape keywords are not supported.
Note
transceiver
[detail |
properties]
(Optional) Display the physical properties of a coarse wavelength-division
multiplexer (CWDM) or dense wavelength-division multiplexer (DWDM) small
form-factor (SFP) module interface. The keywords have these meanings:
• detail—(Optional) Display calibration properties, including high and low
numbers and any alarm information.
• properties—(Optional) Display speed, duplex, and inline power settings on
an interface.
trunk Display interface trunk information. If you do not specify an interface, only
information for active trunking ports appears.
Release Modification
12.2(46)SE The tengigabitethernet interface-id transceiver detail keywords were
added.
12.2(40)EX1 This command was introduced.