Specifications

2-632
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13270-06
Chapter Cisco Catalyst Blade Switch 3130 for Dell Cisco IOS Commands
show monitor
show monitor
Use the show monitor command in EXEC mode to display information about all Switched Port
Analyzer (SPAN) and Remote SPAN (RSPAN) sessions on the switch. Use the command with keywords
to show a specific session, all sessions, all local sessions, or all remote sessions.
show monitor [session {session_number | all | local | range list | remote} [detail]]
Syntax Description
Command Modes User EXEC
Privileged EXEC
Command History
Usage Guidelines The output is the same for the show monitor command and the show monitor session all command.
Examples This is an example of output for the show monitor command:
Switch# show monitor
Session 1
---------
Type : Local Session
Source Ports :
RX Only : Gi4/0/1
Both : Gi4/0/2-3,Gi4/0/5-6
Destination Ports : Gi4/0/10
Encapsulation : Replicate
Ingress : Disabled
Session 2
---------
Type : Remote Source Session
Source VLANs :
TX Only : 10
session (Optional) Display information about specified SPAN sessions.
session_number Specify the number of the SPAN or RSPAN session. The range is 1 to 66.
all Display all SPAN sessions.
local Display only local SPAN sessions.
range list Display a range of SPAN sessions, where list is the range of valid sessions,
either a single session or a range of sessions described by two numbers, the
lower one first, separated by a hyphen. Do not enter any spaces between
comma-separated parameters or in hyphen-specified ranges.
Note This keyword is supported only in privileged EXEC mode.
remote Display only remote SPAN sessions.
detail (Optional) Display detailed information about the specified sessions.
Release Modification
12.2(40)EX1 This command was introduced.