Specifications

2-803
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13270-06
Chapter Cisco Catalyst Blade Switch 3130 for Dell Cisco IOS Commands
switchport trunk
switchport trunk
Use the switchport trunk interface configuration command on the switch stack or on a standalone switch
to set the trunk characteristics when the interface is in trunking mode. Use the no form of this command
to reset a trunking characteristic to the default.
switchport trunk {allowed vlan vlan-list | encapsulation {dot1q | negotiate} | native vlan vlan-id
| pruning vlan vlan-list}
no switchport trunk {allowed vlan | encapsulation | native vlan | {pruning vlan}
Syntax Description
The vlan-list format is all | none | [add | remove | except] vlan-atom [,vlan-atom...] where:
• all specifies all VLANs from 1 to 4094. This keyword is not allowed on commands that do not
permit all VLANs in the list to be set at the same time.
• none means an empty list. This keyword is not allowed on commands that require certain VLANs
to be set or at least one VLAN to be set.
• add adds the defined list of VLANs to those currently set instead of replacing the list. Valid IDs are
from 1 to 1005; extended-range VLANs (VLAN IDs greater than 1005) are valid in some cases.
Note You can add extended-range VLANs to the allowed VLAN list, but not to the
pruning-eligible VLAN list.
Separate nonconsecutive VLAN IDs with a comma; use a hyphen to designate a range of IDs.
allowed vlan vlan-list Set the list of allowed VLANs that can receive and send traffic on this
interface in tagged format when in trunking mode. See the following vlan-list
format. The none keyword is not valid. The default is all.
encapsulation dot1q Set the encapsulation format on the trunk port to IEEE 802.1Q. With this
format, the switch supports simultaneous tagged and untagged traffic on a
port.
encapsulation
negotiate
Specify to use Dynamic Trunking Protocol (DTP) negotiation for the
encapsulation format.
native vlan vlan-id Set the native VLAN for sending and receiving untagged traffic when the
interface is in IEEE 802.1Q trunking mode. The range is 1 to 4094.
pruning vlan vlan-list Set the list of VLANs that are eligible for VTP pruning when in trunking
mode. The all keyword is not valid.