Specifications

B-71
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-06
Appendix B Cisco Catalyst Blade Switch 3130 for Dell Debug Commands
debug platform udld
debug platform udld
Use the debug platform udld privileged EXEC command to enable debugging of the
platform-dependent UniDirectional Link Detection (UDLD) software. Use the no form of this command
to disable debugging.
debug platform udld [all | error | rpc {events | messages}]
no debug platform udld [all | error | rpc {events | messages}]
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform udld command is the same as the no debug platform udld command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
all (Optional) Display all UDLD debug messages.
error (Optional) Display error condition debug messages.
rpc {events | messages} (Optional) Display UDLD remote procedure call (RPC) debug messages.
The keywords have these meanings:
• events—Display UDLD RPC events.
• messages—Display UDLD RPC messages.
Release Modification
12.2(40)EX1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.