User guide

4-12
Configuration Guide for Cisco DSLAMs with NI-2
OL-2074-03
Chapter 4 Configuring Digital Subscriber Lines
Using DSL Profiles
Attaching or Detaching a Profile
This section describes how to attach a profile to or detach a profile from a slot or port.
To attach a profile from a slot or port, follow these steps:
To detach a profile from a slot or port, follow these steps:
Example
This example attaches the profile “test1” to slot 20, port 1, and displays the results:
DSLAM# configure terminal
DSLAM(config)# interface atm 20/1
DSLAM(config-if)# dsl profile test1
DSLAM(config-if)# exit
DSLAM(config)# exit
DSLAM# show dsl interface atm 20/1
Port Status:
Subscriber Name: Circuit ID:
IOS admin: UP oper: UP Card status: Present
Last Change: 36352 days, 13 hrs, 51 min, 47 sec No. of changes: 0
Line Status: TRAINED
Test Mode: NONE
ADSL Chipset Self-Test: NONE
CO Modem Firmware Version: O.21
Configured:
DMT Profile Name: fast
Link Traps Enabled: NO
Alarms Enabled: NO
ATM Payload Scrambling: Enabled
.
.
.
Command Task
Step 1
DSLAM# configure terminal
Go to global configuration mode.
Step 2
DSLAM(config)# interface atm slot/port
Go to interface configuration mode and specify the
slot/port to which you want to attach the profile.
Step 3
DSLAM(config-if)# dsl profile profile-name
Attach profile-name to the slot/port.
Command Task
Step 1
DSLAM# configure terminal
Go to global configuration mode.
Step 2
DSLAM(config)# interface atm slot/port
Go to interface configuration mode and specify the
slot/port from which you want to detach the profile.
Step 3
DSLAM(config-if)# no dsl profile profile-name
Detach profile-name from the specified slot/port.