User guide

4-15
Configuration Guide for Cisco DSLAMs with NI-2
OL-2074-03
Chapter 4 Configuring Digital Subscriber Lines
Setting DSL Profile Parameters
To enable DSL alarms, follow these steps:
To disable DSL alarms, follow these steps:
Example
This example enables alarms for the default profile and displays the results:
DSLAM# configure terminal
DSLAM(config)# dsl-profile default
DSLAM(cfg-dsl-profile)# alarms
DSLAM(cfg-dsl-profile)# end
DSLAM# show dsl profile default
dsl profile default:
Link Traps Enabled: NO
Alarms Enabled: YES
ATM Payload Scrambling: Enabled
DMT profile parameters
Maximum Bitrates:
Interleave Path: downstream: 640/kbs, upstream: 128/kbs
Minimum Bitrates:
Interleave Path: downstream: 0/kbs, upstream: 0/kbs
.
.
.
Command Task
Step 1
DSLAM# configure terminal
Go to global configuration mode.
Step 2
DSLAM(config)# dsl-profile profile-name
Specify a profile.
Step 3
DSLAM(cfg-dsl-profile)# alarms
Enable alarms for that profile.
Step 4
DSLAM(cfg-dsl-profile)# end
Exit from profile configuration mode.
Command Task
Step 1
DSLAM# configure terminal
Go to the global configuration mode.
Step 2
DSLAM(config)# dsl-profile profile-name
Specify a profile.
Step 3
DSLAM(cfg-dsl-profile)# no alarms
Disable alarms for that profile.
Step 4
DSLAM(cfg-dsl-profile)# end
Exit from profile configuration mode.