User guide

3-10
Configuration Guide for Cisco DSLAMs with NI-2
OL-2074-03
Chapter 3 Initially Configuring the Cisco DSLAM
Modifying the Physical Layer Configuration of the Default ATM Interface
Last clearing of "show interface" counters 3w1d
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
435 packets input, 23055 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
4220 input errors, 4355 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
374 packets output, 19822 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
In this example, the OC-3 physical layer configuration is displayed after you modify the defaults:
DSLAM# show running-config
Building configuration...
Current configuration : 3080 bytes
!
version 12.2
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname ra6260_3
!
boot system tftp://64.101.176.211/test_image
slot 1 ATUC-4FLEXIDMT
slot 2 STUC-4-2B1Q-DIR-1
slot 3 ATUC-4FLEXICAP
slot 4 ATUC-4FLEXIDMT
slot 5 ATUC-1-DMT8
slot 6 ATUC-1-4DMT
slot 10 NI-2-155SM-155SM
slot 18 ATUC-1-4DMT
no logging console
enable password test
!
!
dsl-profile default
!
network-clock-select 1 ATM0/1
redundancy
ip subnet-zero
no ip domain-lookup
!
!
no atm oam intercept end-to-end
atm address 47.0091.8100.0000.0004.6dce.7401.0004.6dce.7401.00
atm router pnni
no aesa embedded-number left-justified
node 1 level 56 lowest
redistribute atm-static
!
!
!
!
interface ATM0/0
no ip address
atm maxvp-number 0
atm maxvc-number 4096
!
interface Ethernet0/0