User guide

3-11
Configuration Guide for Cisco DSLAMs with NI-2
OL-2074-03
Chapter 3 Initially Configuring the Cisco DSLAM
Configuring IP Interface Parameters
ip address 10.91.209.71 255.255.255.0
!
interface ATM0/1
no ip address
sonet stm-1
no scrambling sts-stream
no scrambling cell-payload
no atm ilmi-keepalive
!
interface ATM0/2
no ip address
no atm ilmi-keepalive
!
interface ATM1/1
no ip address
no atm ilmi-keepalive
!
interface ATM1/2
no ip address
no atm ilmi-keepalive!
!
ip classless
ip route 0.0.0.0 0.0.0.0 10.91.209.1
no ip http server
ip pim bidir-enable
!
!
!
line con 0
exec-timeout 0 0
line aux 0
line vty 0 4
exec-timeout 0 0
password test
login
!
end
Configuring IP Interface Parameters
This section describes how to configure IP addresses on the DSLAM processor interfaces. You configure
each IP address for one of the following types of connections:
• Ethernet port—Configure either from the BOOTP server or by using the ip address command in
interface-configuration mode for the Ethernet 0/0 interface.
• Serial Line Internet Protocol/Point-to-Point Protocol (SLIP/PPP)—See Chapter 2, “Configuring
Terminal Lines and Modem Support.”
Note These IP connections are used only for network management.
To configure the DSLAM to communicate using the Ethernet interface, provide the IP address and
subnet mask bits for the interface as described in this section.