Installation guide

10
Release Notes for the Catalyst 3750 Switch Cisco IOS Release 12.1(14)EA1
OL-4215-01
Installation Notes
Figure 4 Express Setup Home Page
If the Express Setup does not run, or the Express Setup home page does not appear in your browser:
• Did you wait 30 seconds after connecting the switch and PC or workstation before entering the IP
address in your browser?
If not, wait 30 seconds and re-enter 10.0.0.1 and press Enter.
• Did you enter the wrong address in your web browser, or is there an error message displayed in the
browser window?
Re-enter 10.0.0.1 and press Enter.
• Did you connect a crossover instead of a straight-through Ethernet cable between an Ethernet port
of the switch and the Ethernet port of the PC or workstation, as shown Figure 2?
If not, reconnect the cable to the Ethernet port on the switch and PC or workstation. Wait 30 seconds
before entering 10.0.0.1 in the browser.
• Did you verify that POST successfully ran before starting Express Setup?
If not, make sure that only the SYST and STAT LEDs are green before pressing the Mode button to
begin Express Setup.
Note The rest of this section explains how to configure a switch by using the Express Setup web page. To
configure the switch by using the CLI-based setup program, refer to the switch hardware installation
guide.
Configuring the Switch Settings
The Management Interface field displays VLAN1-Default. This is the management interface through
which you manage the switch and to which you assign IP information.