Manual

2-2
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3522 BRI Gateway and 3527 PRI Gateway Releases 5.6 and 5.7
OL-17010-01
Chapter 2 Setting Up Your Cisco Unified Videoconferencing 3500 Gateway
Physical Description
Front Panel
Figure 2-1 shows the front panel of the Cisco Unified Videoconferencing 3500 Gateway unit. Table 2-1
describes the components of the front panel.
Figure 2-1 Cisco Unified Videoconferencing 3500 Gateway Front Panel
Cisco Unified Videoconferencing 3527 PRI Gateway Rear Panel
Figure 2-2 shows the rear panel components of the Cisco Unified Videoconferencing 3527 PRI Gateway
unit. Table 2-2 describes these components.
Figure 2-2 Cisco Unified Videoconferencing 3527 PRI Gateway: Rear Panel
Ta b l e 2-1 Front Panel Components
Component Description
10/100 BaseT connector An RJ-45 connector that provides the primary Ethernet connection for the IP
network port.
SERIAL connector A DB-9 connector that allows you to connect a PC terminal for local
configuration.
RST button Allows you to reset the Cisco Unified Videoconferencing 3500 Gateway unit
manually.
GK Reg LED Lights green when the Cisco Unified Videoconferencing 3500 Gateway unit
is registered with a gatekeeper.
CD LED Lights green when a PRI or BRI line is enabled and a carrier signal is
detected
ACT LED Lights green to indicate that there are active calls in the Cisco Unified
Videoconferencing
3500 Gateway unit.
ALARM LED Lights green to indicate that an error has occurred and the Cisco Unified
Videoconferencing
3500 Gateway unit requires resetting.
10/100 BaseT LEDs The top part of the 10/100 BaseT connector contains two LED indicators.
The left-hand LED lights green when the local IP network link is active. The
right-hand LED lights green if the connection speed is 100 Mbps, and is off
when the connection speed is 10
Mbps.
10/100 Base T
SERIAL
RST
ACTALARM
CDGK Reg
157264
PWR
PORT-1PORT-2
ACT
157266
D-Ch
ALARM
ACT
D-Ch
ALARM