Installation guide

1-2
Catalyst 3560 Switch Hardware Installation Guide
OL-6337-03
Chapter 1 Product Overview
Front Panel Description
• Gigabit Ethernet
– Catalyst 3560G-24PS switch—24 10/100/1000 PoE ports and 4 SFP module slots
– Catalyst 3560G-24TS switch—24 10/100/1000 ports and 4 SFP module slots
– Catalyst 3560G-48PS switch—48 10/100/1000 PoE ports and 4 SFP module slots
– Catalyst 3560G-48TS switch—48 10/100/1000 ports and 4 SFP module slots
• The switches support these SFP modules:
– 1000BASE-SX
– 1000BASE-LX
– 1000BASE-ZX
– 1000BASE-T
– 100BASE-FX
– Coarse Wavelength-Division Multiplexing (CWDM)
Note When installed in Catalyst 3560 switches, 1000BASE-T SFP modules can operate at 10, 100, or
1000 Mbps in full-duplex mode or at 10 or 100 Mbps in half-duplex mode.
• These switches support the SFP module patch cable. (Order the SFP module patch cable separately,
part number CAB-SFP-50CM=.)
• Configuration
– For 10/100 and 10/100/1000 ports, the speed and duplex settings are autonegotiated.
– For 10/100 and 10/100/1000 ports, PoE settings are autonegotiated.
– For 1000BASE-T SFP module ports, the speed and duplex settings are autonegotiated.
• Switches are hot-swappable.
• Power redundancy
– Connection for optional Cisco RPS 675 that operates on AC input and supplies backup DC
power output to the switches.
Front Panel Description
The Catalyst 3560 switch front panel descriptions include these sections:
• FastEthernet Switch Front Panel Descriptions, page 1-3
• Gigabit Ethernet Switch Front Panel Descriptions, page 1-5
• 10/100 and 10/100/1000 Ports, page 1-6
• SFP Module Slots, page 1-8
• LEDs, page 1-9
• Power Connectors, page 1-14
• Console Port, page 1-15