Installation guide

C-2
Catalyst 3560 Switch Hardware Installation Guide
OL-6337-03
Appendix C Configuring the Switch with the CLI-Based Setup Program
Taking Out What You Need
After you have entered the configuration information for the switch, save it to flash memory by using
the write memory privileged EXEC command.
Note While in Express Setup mode, the IP address 10.0.0.1 is active until you enter the write memory
command. You lose the Telnet connection after entering the write memory command.
For more information about using the CLI, see the switch command reference for this release.
Accessing the CLI Through the Console Port
You can access the CLI on a configured or unconfigured switch by connecting the console port of the
switch to the serial port on your PC or workstation and accessing the switch through a Telnet session.
To access the switch through the console port, follow these steps:
• “Taking Out What You Need” section on page C-2.
• “Connecting to the Console Port” section on page C-3
• “Starting the Terminal-Emulation Software” section on page C-4
• “Connecting to a Power Source” section on page C-5
• “Entering the Initial Configuration Information” section on page C-6
Taking Out What You Need
Remove the items shown in Figure C-1 from the shipping container:
Figure C-1 The Catalyst 3560 Switch, Adapter Cable, and AC Power Cord
Catalyst 3560
S
E
R
IE
S
P
o
E
-4
8
S
Y
S
T
R
P
S
S
T
A
T
D
U
P
L
X
S
P
E
E
D
P
o
E
M
O
D
E
1
2
3
4
1
2
5
6
7
8
9
1
0
1
1
1
2
1
3
1
4
1
5
1
6
3
4
1
X
2
X
1
5
X
1
6
X
1
7
1
8
2
12
2
2
3
2
4
2
5
2
6
2
7
2
8
2
9
3
0
3
1
3
2
1
9
2
0
1
7
X
1
8
X
3
1
X
3
2
X
3
3
3
4
3
7
3
8
3
9
4
0
4
1
4
2
4
3
4
4
4
5
4
6
4
7
4
8
3
5
3
6
3
3
X
3
4
X
4
7
X
4
8
X
1
2
3
97933