Specifications

7-5
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 7 Configuring Transparent SCSI Routing
Verifying Configuration
The following explains the Initiator and State fields:
Use the following procedure to verify discovered targets.
Example 7-4 Verifying Discovered Targets
[SN5428-2]# show devices
Fabric Attached Devices detected
Interface WWPN PortId Device Type Lun Lunid Type Lunid
--------- ---------------- -------- --------------- ----- ----------------- -----
fc1 22000004cf4304cd 0x101e2 DASD 0 IEEE Extended 200f
fc1 2200002037559b0e 0x101e1 DASD 0 IEEE Extended 200b
Lun Description Table
Interface WWPN Lun Capacity Vendor Product Serial
--------- ---------------- ----- -------- ------------ ------------ ------
fc1 22000004cf4304cd 0 17GB SEAGATE ST318452FC 3EV0N8B4000M
fc1 2200002037559b0e 0 17GB SEAGATE ST318451FC 3EV0N7CW0002
Initiator Initiator 0 is reserved for the primary initiator port. This port performs the
discovery of the target devices—the same devices that appear in the
show devices command. This port is not available to IP hosts. The port’s
IP address is the one assigned to the SN 5428-2 management interface,
and its IP host name is the system name of the SN 5428-2 with
“iqn.1987-05.com.cisco.00.” preceding it.
Initiators 1 to 62 (1 to 31 on each port) are used for IP hosts that are
logged in. For instance in Example 7-2, IP host, NT10, is bound to
initiator port 1 with WWPN 200100023d070740.
State Login state:
0 and 1—(not used)
2—PLOGI request has queued to request queue
3—PLOGI response has been received
4—PLOGI response received and PRLI request queued to request queue
5—PRLI response received
6—PRLI ACC received (login successful)
7—Initial port state (not logged in)
8—LOGO is queued to request queue
9—LOGO has been transmitted
Command Description
Step 1
enable Enter Administrator mode.
Step 2
show devices Display discovered targets (Fibre Channel devices).
(Example 7-4.)