Specifications

12-321
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
scsirouter target lun lunid
Use the force keyword to allow mapping of the same storage array control LUN in multiple targets. Do
not use the force keyword to LUN-map the same data LUN in multiple targets. LUN-mapping of the
same LUN in multiple targets is advised for a control LUN on a storage controller only.
Examples The following example maps a logical target and LUN combination for SCSI router instance foo. The
logical target and LUN combination, webserver5 LUN 5, is mapped to the physical LUN represented by
the LUN identifier 200000203719129d.
[SN5428-2A]# scsirouter foo target webserver5 lun 5 lunid 220000203719129d
Related Commands Command Description
accesslist Create an access list entity.
accesslist A.B.C.D/bits Add IP addresses to an access list.
accesslist
chap-username
Add CHAP user name entries to an access list.
accesslist iscsi-name Add iSCSI Name entries to an access list.
delete accesslist Delete a specific access list entry or an entire access list.
delete scsirouter Delete the named SCSI routing instance or the specified element of the
SCSI routing instance.
restore accesslist Restore the named access list or all access lists from the named
configuration file.
restore scsirouter Restore the named SCSI routing instance from the named configuration file.
save accesslist Save configuration data for the named access list or all access lists.
save scsirouter Save configuration information for the named SCSI routing instance.
scsirouter Create a SCSI routing instance.
scsirouter enable Stop or start the named SCSI routing instance.
scsirouter primary Identify a storage router as the preferred storage router to run the named
SCSI routing instance.
scsirouter serverif Assign a Gigabit Ethernet interface, IP address, and optionally a VLAN to
the named SCSI routing instance.
scsirouter target
accesslist
Associate an access list with a specific SCSI routing instance target or all
targets.
scsirouter target
enable
Allow or disallow connections and logins for the named target.
setup scsi Run the wizard to configure a SCSI routing instance.
show accesslist Display the contents of the named access list or all access lists.
show scsirouter Display configuration and operational information for the named SCSI
routing instance.