Specifications

12-348

Cisco SN 5428-2 Storage Router Software Configuration Guide

78-15471-01

Chapter 12 Command Line Interface Reference

setup fcip

To configure an FCIP instance, use the setup fcip configuration wizard. The wizard prompts you to

choose the name of the FCIP instance and specify the Gigabit Ethernet IP address and network mask.

Then the wizard prompts you to enter the peer IP address and the connection protocol type. More

extensive configuration of FCIP instances can be performed via the CLI or the web-based GUI.

setup fcip [parameter1 parameter2...]

Syntax Description

Defaults Defaults or current values are shown in parentheses within the allowable response brackets. In the

following example, the current default FCIP instance name is fcip1.

Create which FCIP instance ? [fcip1/fcip2 (fcip1)]

Command Modes Administrator.

Command History

Usage Guidelines The setup fcip command can only be run when at least one FCIP instance is not currently configured on

the storage router; if both FCIP instances are configured, you cannot run the setup fcip wizard. Only one

setup wizard can be active at any given time. Multiple users cannot run multiple setup wizards

concurrently.

Use the optional parameter arguments to run the setup fcip wizard from a command script. All

parameters required by the wizard must be included. The setup fcip wizard will not complete unless all

parameters are passed.

Note If too many parameters are passed, the setup fcip wizard will ignore the extra parameters and may

complete. If a parameter is not in the correct format or is otherwise invalid, the next parameter is used

to attempt to fulfill the prompt. In either case, unexpected results could occur. Always check the output

from a setup fcip command when using the parameter arguments.

parameter1 parameter2

...

(Optional) Enter each parameter that the wizard prompts for. All parameters

must be passed. If a parameter includes an embedded space, enclose the

parameter in quotation marks.

Release Modification

3.3.1 This command was introduced.