Specifications

12-356
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
setup netmgmt
Examples The following shows example output and input for the setup netmgmt command:
[SN5428-2A]# setup netmgmt
#####################################
## Network Management Access Setup ##
#####################################
This wizard will enable you to configure access to telnet, the web-based
GUI, and configure SNMP. By default, telnet and the web-based GUI are
enabled. SNMP gets via the "public" community are also enabled via the
10/100 management interface. If you want to change these values or configure
other SNMP features, please set up the network management.
Set up Network Management ? [yes/no (yes)] yes
Enable telnet on all interfaces? [yes/no (yes)] yes
Configure SNMP ? [yes/no (yes)] yes
If you select to configure SNMP, the wizard prompts you for the following information:
Read Community ? [public]
Write Community ? [private] mynetmanagers
First IP address for SNMP traps ? [A.B.C.D] 10.1.30.17
Trap version for first IP address? [1/2 (1)]
Second IP address for SNMP traps ? [A.B.C.D] 10.1.30.18
Trap version for second IP address? [1/2 (1)]
Send auth trap when requester specifies
incorrect community? [yes/no (no)] yes
Modify link up/down traps for one or more interfaces? [yes/no (yes)] yes
Send link up/down traps for MGMT interface? [yes/no (yes)] yes
Send link up/down traps for HA interface? [yes/no (yes)] yes
Send link up/down traps for GE interface? [yes/no (yes)] no
Send link up/down traps for fibre
channel interface? [yes/no (yes)] yes
The wizard ends by displaying the following information:
Network Management setup is complete.
By default, these methods of network management will work from any network
which is not separated from the SN5428-2 by a firewall or other traffic-limiting
device. To further specify security requirements, please use the normal
configuration functions of the CLI or GUI after completing this wizard.
Done with setup.