Specifications

3-4
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 3 Configuring System Parameters
Configuring Time and Date
Configuring Time and Date
Configuring time and date parameters consists of specifying the time zone, time, date and time server.
Use the following procedure to configure the time and date parameters.
Step 3
interface mgmt ip-address
10.1.10.244/24
Specify or change the IP address and subnet mask for the
management interface.
Note If this storage router is to participate in a cluster, the
management interface for all storage routers in the cluster
must be on the same IP subnet.
Step 4
interface ge1 ip-address
10.1.70.85/24 secondary ge2
(Optional) Configure an IP address and subnet mask on ge1 to be
used for SN 5428-2 management and maintenance. Specify ge2 as
the secondary interface for this IP address. If the Gigabit Ethernet
interface ge1 becomes unavailable and ge2 is available, the IP
address will become active on ge2.
Note If you configure a Gigabit Ethernet IP address with a
secondary interface, all Gigabit Ethernet IP addresses on
the same subnet must also be configured with the same
secondary interface.
Step 5
no restrict ge1 ssh
no restrict ge2 ssh
(Optional) Configure the Gigabit Ethernet interfaces to be used for
management and maintenance for access via the desired
protocol(s). In this configuration example, management access to
the SN 5428-2 through the configured Gigabit Ethernet IP address
is allowed for both ge1 and ge2 via Secure Shell (SSH) protocols.
Step 6
ip name-server 10.1.40.243
10.1.50.249
(Optional) Set the primary and secondary DNS IP addresses.
Specifies the IP address of the primary DNS server if the
management interface IP address is to be correlated with a DNS
host name. If there is a secondary DNS, the second IP address
specifies the IP address of the secondary DNS server.
Step 7
ip domain-name
mystoragenet.com
(Optional) Specify the domain name of the storage router. Use this
command in conjunction with the ip name-server command.
Command Description
Command Description
Step 1
enable Enter Administrator mode.
Step 2
clock timezone US/Pacific Identify the time zone where the storage router is located. If a time
zone is not identified, time is assumed to be GMT.
Note To use the clock timezone command, you must use a valid
time-zone string. For a list of valid time-zone strings, use
the clock timezone ? command. See Chapter 12,
“Command Line Interface Reference,” for details.