Specifications

12-454
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
show interface
Logout Count Incremented when a user logs out.
Invalid Dest Add Number of invalid destination addresses received.
Class2 Frames In Number of class 2 frames received by this port.
Class3 Frames In Number of class 3 frames received by this port.
Total Rx Frames Total number of frames received by this port.
Class2 Frames Out Number of class 2 frames sent by this port.
Class3 Frames Out Number of class 3 frames sent by this port.
Total Tx Frames Total number of frames issued by this port.
Class2 Words In Number of class 2 words received by this port.
Class3 Words In Number of class 3 words received by this port.
Total Rx Words Total number of words received by this port.
Class2 Words Out Number of class 2 words sent by this port.
Class3 Words Out Number of class 3 words sent by this port.
Total Tx Words Total number of words issued by this port.
Decode Error Count Number of decoding errors detected.
Invalid CRC Count Number of invalid CRCs detected.
Class3 Toss Count Number of class 3 frames tossed.
FBusy Count The number of times the switch sent a P_BSY because a Class 2 frame
could not be delivered within a specified time period; the number of
class 2 and class 3 fabric busy (F_BSY) frames generated by this port
in response to incoming frames. This usually indicates a busy condition
on the fabric that is preventing delivery of this frame.
Flow Error Count Number of flow errors.
Primitive Seq Errors Primitive sequence errors detected.
Loss of Sync Count Number of synchronization losses detected by this port. A loss of
synchronization (greater than 100 ms) is detected by the receipt of an
invalid transmission word.
Tx Wait Count Time waiting to transmit when blocked with no credit. Measured in FC
Word times.
FReject Count Number of frames from devices that were rejected.
Link Failures Number of optical link failures detected by this port. A link failure is a
loss of synchronization for a period of time greater than the timeout
value or by loss of signal while not in the offline state. A loss of signal
causes the switch to attempt to re-establish the link. If the link is not
re-established by the time specified, a link failure is counted. A link
reset is performed after a link failure.
LP_TOV Timeout Count Number of times the timeout value on the local port has been triggered.
Rx Link Resets Number of link reset primitives received from an attached device.
Tx Link Resets Number of link resets issued by this port.
Table 12-33 Description of Port Attributes in the “show interface stats” Command Output (continued)
Port Attribute Description