System information

12-156

Cisco SN 5428-2 Storage Router Software Configuration Guide

78-15471-01

Chapter 12 Command Line Interface Reference

fcswitch zoning merge

To set zoning merge compliance, use the fcswitch zoning merge command.

fcswitch zoning merge sw2

Syntax Description

Defaults The SN 5428-2 Storage Router is FC-SW-2 compliant, and is configured to participate in a fabric with

only FC-SW-2 compliant switches by default.

Command Modes Administrator.

Command History

Usage Guidelines By default, the SN 5428-2 Storage Router can merge into existing FC switched fabric zones and

participate in the zoning. All switches in a fabric should be set to the same merge mode to prevent

switches from becoming isolated from each other. By default, the storage router supports the FC-SW-2

compliant merge mode.

Examples The following example sets the merge mode for participation in a fabric with FC-SW-2 compliant

switches:

[SN5428-2A]# fcswitch zoning merge sw2

sw2 Indicates the fabric includes only FC-SW-2 compliant switches. A merge

may only occur of active zoning information, ensuring all switches have

identical active zone sets. This is the default.

Release Modification

3.2.1 This command was introduced.