System information

12-349
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
setup fcip
Examples The following shows example output and input for the setup scsi command:
[techpubs4]# setup fcip
In order to correctly configure this FCIP instance, be sure you know
the configuration of the remote FCIP instance. You will need to know
the IP address and the communication protocol of the remote FCIP instance.
In addition, you will need to ensure that the Fibre Channel domain ID you
assign is different than the Fibre Channel domain ID assigned to the remote
SN 5428-2-K9.
The system enables you to create two FCIP instances. Each instance
uses a different Fibre Channel interface and gigabit Ethernet interface.
Create which FCIP instance ? [fcip1/fcip2 (fcip1)] fcip2
Please specify an IP address and netmask for the gigabit
Ethernet interface.
IP address? [A.B.C.D/nn] 10.1.0.16/24
If both gigabit Ethernet interfaces are cabled to the same network, you
can configure the FCIP instance to failover to the secondary interface
in case of a failure on the primary interface.
Configure secondary interface for the FCIP instance? [yes/no (no)] no
Please enter the IP address of the remote FCIP instance to
which you wish to connect.
IP address of remote FCIP instance? [A.B.C.D] 10.1.0.47
Choose how you want the FCIP instance to communicate with the
remote FCIP instance. If the remote FCIP instance is configured to use raw IP,
select raw as the protocol. If the remote FCIP instance is configured as a TCP
server, select client. If the remote FCIP instance is configured as a TCP client,
select server.
Use which protocol? [raw/client/server] raw
If this is the first FCIP instance to be configured on the storage router, you will be prompted to specify
a Fibre Channel domain ID:
Please specify a domain ID for use by this FCIP instance. This
domain ID must be unique. It can not be assigned to any switch in the Fibre
Channel fabric that this switch is connected to or assigned to any switch
in the remote Fibre Channel network.
Domain ID for the Fibre Channel switch? [1 - 127] 80
set Domain ID on Fibre Channel interfaces to 80
Mar 14 15:08:48: %FC-5-FCIP09: fcip2 has been started
FCIP, fcip2, created
Mar 14 15:08:48: %UI-5-FAFD2: Added FCIP device fci2
Mar 14 15:08:48: %UI-5-NMAOOI: Address 10.1.0.16/24 is now operational on interface ge1
Mar 14 15:08:48: %UI-5-FAFNI: Added FCIP network interface ge2, 10.1.0.16/255.255.255.0
FCIP-2: addPeer raw 10.1.0.47
Mar 14 15:08:48: %UI-5-FAFD: Added FCIP destination dest2 (raw, 10.1.50.50)
Configuration complete.
FCIP instance fcip2 is now configured.
Done with setup.