System information

12-427
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
show fcip
The following is example output from the show fcip stats command:
[SN5428-2A]# show fcip all stats
fcip1
-----
Mode tcpclient
Destination Address 10.1.40.170
Connected Yes
fcip1 Stats
-----------
Link up events 1
Link down events 0
Connect events 1
Network connections established 1
Network flow controlled 1
fcip2
-----
Mode raw
Destination Address 10.1.50.53
Connected Yes
fcip2 Stats
-----------
Link up events 1
Link down events 0
Connect events 1
Network connections established 1
Network flow controlled 1
Related Commands Command Description
clear counters fcip Reset accumulated operational statistics for the specified SCSI routing
instance.
fcip Create an FCIP instance.
fcip description Add user-defined identification information to the named FCIP instance.
fcip destination config Configure operational parameters for the named FCIP instance.
fcip destination raw Add a peer destination to the named FCIP instance, with a connection type
of raw IP.
fcip destination
tcpclient
Add a peer destination to the named FCIP instance, with a connection type
of TCP/IP. The named FCIP instance initiates the TCP connection.
fcip destination
tcpserver
Add a peer destination to the named FCIP instance, with a connection type
of TCP/IP. The named FCIP instance listens for the TCP connection from
the named destination.
fcip networkif Assign a Gigabit Ethernet interface and IP address to the named FCIP
instance.
restore fcip Restore the named SCSI routing instance from the named configuration file.
save fcip Save configuration information for the named FCIP instance.